guide / OAKNEST-111 / all figures in mm

Sizing for NZ and AU homes

Furniture fails in rooms, not showrooms. These are the numbers to check with a tape measure before you buy anything — from us or anyone.

Dining tables

Allow 600 mm of table edge per diner, and 900 mm of clear floor between table edge and wall for chairs to pull out — 1,200 mm where people walk behind seated diners.

Rectangular table length by seat count (760–1,000 mm width assumed)
seatstable lengthmin. room length (table + 2×900)
41,200–1,4003,000–3,200
61,600–1,8003,400–3,600
82,000–2,4003,800–4,200
102,600–3,0004,400–4,800

Table height is 740–760 mm as standard; check apron clearance if anyone at your table uses a chair with arms — you need roughly 660 mm from floor to the underside of the apron.

Beds — the actual NZ/AU dimensions

NZ and AU bed sizes are their own system. A "king" here is not a UK king or a US king, and imported bedding and frames regularly don't match local mattresses. Measure your mattress; don't trust the name.

Standard NZ/AU mattress sizes (mm)
sizeNZ / AUfor comparison
single920 × 1,880 / 1,900UK single 900 × 1,900
king single1,070 × 2,030no UK/US equivalent
double1,370 × 1,880 / 1,900UK double 1,350 × 1,900
queen1,530 × 2,030US queen 1,525 × 2,030
king1,670 (NZ) / 1,830 (AU) × 2,030UK king 1,500 × 2,000
super king1,830 (NZ) / 2,030 (AU) × 2,030US king 1,935 × 2,030

Note the NZ/AU split on king and super king — a frame made for one market can be 150 mm off in the other. Around the bed, allow 600 mm on each access side and 900 mm at the foot if there's a walkway.

Coffee tables and living

A coffee table works at half to two-thirds the sofa's length, its top within 50 mm of the seat cushion height (usually 400–450 mm), placed 350–450 mm from the sofa — close enough to reach, far enough to walk. Sideboards: 400–450 mm deep is enough for dinnerware; leave 1,000 mm in front for doors and drawers plus a person.

Will it get in? Delivery access

Solid furniture doesn't flat-pack, so check the route before ordering. Measure the narrowest of: front door (NZ standard is 810–860 mm clear), hallway width including skirting, stair width and any landing turn, and lift door if apartment. A piece can enter on the diagonal — as a rule of thumb, if the piece's smallest two dimensions each fit the doorway's width and the route has no tight turn, it will go. When our range launches, every product page will state the piece's packed dimensions and the minimum door width it needs.

Trade-off, stated: a one-piece solid table top is the best construction and the worst thing to carry up a spiral staircase. If your access is tight, tell us before ordering — not after.

07 / waitlist

Be there when the first shipment lands

One email when the range opens, and at most one a month before that — workshop notes, not promotions. Leave anytime, one click.